H3C Technologies H3C SecPath F1000-E - Manual (Page 110)

10
• RFC 1881: IPv6 Address Allocation Management
• RFC 1887: An Architecture for IPv6 Unicast Address Allocation
• RFC 1981: Path MTU Discovery for IP version 6
• RFC 2375: IPv6 Multicast Address Assignments
• RFC 2460: Internet Protocol, Version 6 (IPv6) Specification.
• RFC 2461: Neighbor Discovery for IP Version 6 (IPv6)
• RFC 2462: IPv6 Stateless Address Autoconfiguration
• RFC 2463: Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6)
Specification
• RFC 2464: Transmission of IPv6 Packets over Ethernet Networks
• RFC 2526: Reserved IPv6 Subnet Anycast Addresses
• RFC 3307: Allocation Guidelines for IPv6 Multicast Addresses
• RFC 3513: Internet Protocol Version 6 (IPv6) Addressing Architecture
IPv6 Basics Configuration Task List
Complete the following tasks to perform IPv6 basics configuration:
Task Remarks
Enabling IPv6 Required
Configuring IPv6 Site-Local Addresses and Global Unicast
Addresses
Configuring an IPv6 Link-Local Address
Configuring Basic IPv6
Functions
Configure an IPv6 Anycast Address
Required
to
configure
one
Configuring a Static Neighbor Entry Optional
Configuring the Maximum Number of Neighbors
Dynamically Learned
Optional
Configuring Parameters Related to RA Messages Optional
Configuring the Maximum Number of Attempts to Send an
NS Message for DAD
Optional
Configuring IPv6 ND
Enabling ND Proxy Optional
Configuring the Interface MTU Optional
Configuring a Static PMTU for a Specified IPv6 Address Optional Configuring PMTU Discovery
Configuring the Aging Time for Dynamic PMTUs Optional
Configuring IPv6 TCP Properties Optional
Configuring IPv6 FIB-Based Forwarding Optional
Configuring the Maximum ICMPv6 Error Packets Sent in an
Interval
Optional
Enabling Replying to Multicast Echo Requests Optional
Configuring ICMPv6 Packet
Sending
Enabling Sending of ICMPv6 Time Exceeded Messages Optional