H3C Technologies H3C SecPath F1000-E - Manual (Page 165)

19
• Configuration on Device A.
# Enable IPv6.
<DeviceA> system-view
[DeviceA] ipv6
# Configure an IPv4 address for GigabitEthernet 1/2.
[DeviceA] interface gigabitethernet 1/2
[DeviceA-GigabitEthernet1/2] ip address 2.1.1.1 24
[DeviceA-GigabitEthernet1/2] quit
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] ipv6 address 2002:0201:0101:1::1/64
[DeviceA-GigabitEthernet1/1] quit
# Configure the 6to4 tunnel.
[DeviceA] interface tunnel 0
[DeviceA-Tunnel0] ipv6 address 2002:201:101::1/64
[DeviceA-Tunnel0] source gigabitethernet 1/2
[DeviceA-Tunnel0] tunnel-protocol ipv6-ipv4 6to4
[DeviceA-Tunnel0] quit
# Configure a static route whose destination address is 2002::/16 and next-hop is the tunnel interface.
[DeviceA] ipv6 route-static 2002:: 16 tunnel 0
• Configuration on Device B
# Enable IPv6.
<DeviceB> system-view
[DeviceB] ipv6
# Configure an IPv6 address for GigabitEthernet 1/2.
[DeviceB] interface gigabitethernet 1/2
[DeviceB-GigabitEthernet1/2] ip address 5.1.1.1 24
[DeviceB-GigabitEthernet1/2] quit
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] ipv6 address 2002:0501:0101:1::1/64
[DeviceB-GigabitEthernet1/1] quit
# Configure a 6to4 tunnel.
[DeviceB] interface tunnel 0
[DeviceB-Tunnel0] ipv6 address 2002:0501:0101::1/64
[DeviceB-Tunnel0] source gigabitethernet 1/2
[DeviceB-Tunnel0] tunnel-protocol ipv6-ipv4 6to4
[DeviceB-Tunnel0] quit
# Configure a static route whose destination address is 2002::/16 and next-hop is the tunnel interface.
[DeviceB] ipv6 route-static 2002:: 16 tunnel 0
Configuration verification
After the above configuration, ping either host from the other, and the ping operation succeeds.
D:\>ping6 -s 2002:201:101:1::2 2002:501:101:1::2