Static ip address assignment configuration example, Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 55
15
The DHCP server configuration for the two types is the same.
Static IP Address Assignment Configuration Example
Network requirements
As shown in
, Device B (DHCP client) and Device C (BOOTP client) obtain a static IP address,
DNS server address, and gateway address from Device A (DHCP server) respectively.
The MAC address of interface GigabitEthernet 0/1 on Device C is 000f-e200-01c0. The client ID of
interface GigabitEthernet 0/1 on Device B is
3030-3066-2e65-3230-302e-3030-3032-2d45-7468-6572-6e65-7430-2f30.
Figure 11 Network diagram for static IP address assignment
Configuration procedure
1.
Configure the IP address of GigabitEthernet 0/1 on Device A.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 0/1
[DeviceA-GigabitEthernet0/1] ip address 10.1.1.1 25
[DeviceA-GigabitEthernet0/1] quit
2.
Configure the DHCP server
# Enable DHCP.
[DeviceA] dhcp enable
# Create DHCP address pool 0, and configure a static binding, DNS server and gateway in it.
[DeviceA] dhcp server ip-pool 0
[DeviceA-dhcp-pool-0] static-bind ip-address 10.1.1.5
[DeviceA-dhcp-pool-0] static-bind client-identifier
3030-3066-2e65-3230-302e-3030-3032-2d45-7468-6572-6e65-7430-2f30
[DeviceA-dhcp-pool-0] dns-list 10.1.1.2
[DeviceA-dhcp-pool-0] gateway-list 10.1.1.126
[DeviceA-dhcp-pool-0] quit
# Create DHCP address pool 1, and configure a static binding, DNS server and gateway in it.
[DeviceA] dhcp server ip-pool 1
[DeviceA-dhcp-pool-1] static-bind ip-address 10.1.1.6
[DeviceA-dhcp-pool-1] static-bind mac-address 000f-e200-01c0
[DeviceA-dhcp-pool-1] dns-list 10.1.1.2