H3C Technologies H3C SecPath F1000-E - Manual (Page 159)

13
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:3201
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 55
...
# Ping the IPv6 address of GigabitEthernet 1/1 at the peer end from Device A.
[DeviceA] ping ipv6 3003::1
PING 3003::1 : 56 data bytes, press CTRL_C to break
Reply from 3003::1
bytes=56 Sequence=1 hop limit=64 time = 1 ms
Reply from 3003::1
bytes=56 Sequence=2 hop limit=64 time = 1 ms
Reply from 3003::1
bytes=56 Sequence=3 hop limit=64 time = 1 ms
Reply from 3003::1
bytes=56 Sequence=4 hop limit=64 time = 1 ms
Reply from 3003::1
bytes=56 Sequence=5 hop limit=64 time = 1 ms
--- 3003::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/1 ms
Configuring an Automatic IPv4-Compatible IPv6
Tunnel
Configuration Prerequisites
Configure IP addresses for interfaces (such as the VLAN interface, GigabitEthernet interface, and
loopback interface) on the device to ensure normal communication. One of the interfaces will be used as
the source interface of the tunnel.
Configuration Procedure
Follow these steps to configure an automatic IPv4-compatible IPv6 tunnel: