H3C Technologies H3C SecPath F1000-E - Manual (Page 77)

3
Configuration procedure
The following describes only the configuration on Device B serving as a client.
# Configure GigabitEthernet 0/1 to dynamically obtain an IP address by using BOOTP.
<DeviceB> system-view
[DeviceB] interface gigabitethernet 0/1
[DeviceB-GigabitEthernet0/1] ip address bootp-alloc
# Use the display bootp client command to view the IP address assigned to the BOOTP client.
NOTE:
To make the BOOTP client obtain an IP address from the DHCP server, you need to perform additional
configurations on the DHCP server. For details, refer to
DHCP Server Configuration Examples .