Configuration procedure, Configuration verification – H3C Technologies H3C SecPath F1000-E User Manual
Page 161
15
Figure 8 Network diagram for an automatic IPv4-compatible IPv6 tunnel
Configuration procedure
NOTE:
Make sure that Device A and Device B are reachable to each other.
•
Configuration on Device A
# Enable IPv6.
<DeviceA> system-view
[DeviceA] ipv6
# Configure an IPv4 address for GigabitEthernet 1/1.
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] ip address 192.168.100.1 255.255.255.0
[DeviceA-GigabitEthernet1/1] quit
# Configure an automatic IPv4-compatible IPv6 tunnel.
[DeviceA] interface tunnel 0
[DeviceA-Tunnel0] ipv6 address ::192.168.100.1/96
[DeviceA-Tunnel0] source gigabitethernet 1/1
[DeviceA-Tunnel0] tunnel-protocol ipv6-ipv4 auto-tunnel
•
Configuration on Device B
# Enable IPv6.
<DeviceB> system-view
[DeviceB] ipv6
# Configure an IPv4 address for GigabitEthernet 1/1.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] ip address 192.168.50.1 255.255.255.0
[DeviceB-GigabitEthernet1/1] quit
# Configure an automatic IPv4-compatible IPv6 tunnel.
[DeviceB] interface tunnel 0
[DeviceB-Tunnel0] ipv6 address ::192.168.50.1/96
[DeviceB-Tunnel0] source gigabitethernet 1/1
[DeviceB-Tunnel0] tunnel-protocol ipv6-ipv4 auto-tunnel
Configuration verification
After the above configurations, display the status of the tunnel interfaces on Device A and Device B,
respectively.
[DeviceA] display ipv6 interface tunnel 0 verbose