H3C Technologies H3C SecPath F1000-E - Manual (Page 167)

21
# Configure an IPv4 address for GigabitEthernet 1/2.
[DeviceA] interface gigabitethernet 1/2
[DeviceA-GigabitEthernet1/2] ip address 2.1.1.1 255.255.255.0
[DeviceA-GigabitEthernet1/2] quit
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] ipv6 address 2002:0201:0101:1::1/64
[DeviceA-GigabitEthernet1/1] quit
# Configure a 6to4 tunnel.
[DeviceA] interface tunnel 0
[DeviceA-Tunnel0] ipv6 address 2002:0201:0101::1/64
[DeviceA-Tunnel0] source gigabitethernet 1/2
[DeviceA-Tunnel0] tunnel-protocol ipv6-ipv4 6to4
[DeviceA-Tunnel0] quit
# Configure a static route to the 6to4 relay device.
[DeviceA] ipv6 route-static 2002:0601:0101:: 64 tunnel 0
# Configure the default route to the IPv6-only network.
[DeviceA] ipv6 route-static :: 0 2002:0601:0101::1
• Configuration on Device B
# Enable IPv6.
<DeviceB> system-view
[DeviceB] ipv6
# Configure an IPv4 address for GigabitEthernet 1/2.
[DeviceB] interface gigabitethernet 1/2
[DeviceB-GigabitEthernet1/2] ip address 6.1.1.1 255.255.255.0
[DeviceB-GigabitEthernet1/2] quit
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] ipv6 address 2001::1/16
[DeviceB-GigabitEthernet1/1] quit
# Configure a 6to4 tunnel.
[DeviceB] interface tunnel 0
[DeviceB-Tunnel0] ipv6 address 2002:0601:0101::1/64
[DeviceB-Tunnel0] source gigabitethernet 1/2
[DeviceB-Tunnel0] tunnel-protocol ipv6-ipv4 6to4
[DeviceB-Tunnel0] quit
# Configure a static route whose destination address is 2002::/16 and next-hop is the tunnel interface.
[DeviceB] ipv6 route-static 2002:: 16 tunnel 0
Configuration verification
After the above configuration, ping Host B from Host A.
D:\>ping6 -s 2002:201:101:1::2 2001::2
Pinging 2001::2
from 2002:201:101:1::2 with 32 bytes of data: