H3C Technologies H3C SecPath F1000-E - Manual (Page 182)

36
[DeviceA-Tunnel1] quit
# Configure a static route from Device A through the interface tunnel 1 to Group 2.
[DeviceA] ipv6 route-static 2002:3:: 64 tunnel 1
• Configuration on Device B
# Enable IPv6.
<DeviceB> system-view
[DeviceB] ipv6
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] ipv6 address 2002:3::1 64
[DeviceB-GigabitEthernet1/1] quit
# Configure an IPv6 address for GigabitEthernet 2/1 (the physical interface of the tunnel).
[DeviceB] interface gigabitethernet 2/1
[DeviceB-GigabitEthernet2/1] ipv6 address 2002::22:1 64
[DeviceB-GigabitEthernet2/1] quit
# Create the interface tunnel 2.
[DeviceB] interface tunnel 2
# Configure an IPv6 address for the interface tunnel 2.
[DeviceB-Tunnel2] ipv6 address 3001::1:2 64
# Configure the tunnel encapsulation mode.
[DeviceB-Tunnel2] tunnel-protocol ipv6-ipv6
# Configure a source address for the interface tunnel 2 (IP address of GigabitEthernet 2/1).
[DeviceB-Tunnel2] source 2002::22:1
# Configure a destination address for the interface tunnel 2 (IP address of GigabitEthernet 2/0 of Device
A).
[DeviceB-Tunnel2] destination 2002::11:1
[DeviceB-Tunnel2] quit
# Configure a static route from Device B through the interface tunnel 2 to Group 1.
[DeviceB] ipv6 route-static 2002:1:: 64 tunnel 2
Configuration verification
After the above configuration, display the status of the tunnel interfaces on Device A and Device B,
respectively.
[DeviceA] display ipv6 interface tunnel 1 verbose
Tunnel1 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2013:1
Global unicast address(es):
3001::1:1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF13:1
FF02::1:FF01:1
FF02::1:FF00:0
FF02::2
FF02::1