Configuration example, Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 157
11
Configuration Example
Network requirements
As shown in
, two IPv6 networks are connected to an IPv4 network through Device A and Device
B respectively. Configure an IPv6 manual tunnel between Device A and Device B to make the two IPv6
networks reachable to each other.
Figure 7 Network diagram for an IPv6 manual tunnel
Configuration procedure
NOTE:
Make sure that Device A and Device B are reachable to each other.
•
Configuration on Device A
# Enable IPv6.
<DeviceA> system-view
[DeviceA] ipv6
# Configure an IPv4 address for GigabitEthernet 1/2.
[DeviceADeviceA] interface gigabitethernet 1/2
[DeviceA-GigabitEthernet1/2] ip address 192.168.100.1 255.255.255.0
[DeviceA-GigabitEthernet1/2] quit
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] ipv6 address 3002::1 64
[DeviceA-GigabitEthernet1/1] quit
# Configure an IPv6 manual tunnel.
[DeviceA] interface tunnel 0
[DeviceA-Tunnel0] ipv6 address 3001::1/64
[DeviceA-Tunnel0] source gigabitethernet 1/2
[DeviceA-Tunnel0] destination 192.168.50.1
[DeviceA-Tunnel0] tunnel-protocol ipv6-ipv4
[DeviceA-Tunnel0] quit
# Configure a static route to IPv6 Group 2 through tunnel 0 on Device A.
[DeviceA] ipv6 route-static 3003:: 64 tunnel 0
•
Configuration on Device B
# Enable IPv6.
<DeviceB> system-view