Configuration example, Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 181
35
Configuration Example
Network requirements
As shown in
, the two subnets Group 1 and Group 2 running IPv6 are interconnected by using
an IPv6 over IPv6 tunnel between Device A and Device B.
Figure 14 Network diagram for an IPv6 over IPv6 tunnel
Configuration procedure
NOTE:
Make sure that Device A and Device B are reachable to each other.
•
Configuration on Device A
# Enable IPv6.
<DeviceA> system-view
[DeviceA] ipv6
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] ipv6 address 2002:1::1 64
[DeviceA-GigabitEthernet1/1] quit
# Configure an IPv6 address for GigabitEthernet 2/0 (the physical interface of the tunnel).
[DeviceA] interface gigabitethernet 2/0
[DeviceA-GigabitEthernet2/0] ipv6 address 2002::11:1 64
[DeviceA-GigabitEthernet2/0] quit
# Create the interface tunnel 1.
[DeviceA] interface tunnel 1
# Configure an IPv6 address for the interface tunnel 1.
[DeviceA-Tunnel1] ipv6 address 3001::1:1 64
# Configure the tunnel encapsulation mode.
[DeviceA-Tunnel1] tunnel-protocol ipv6-ipv6
# Configure a source address for the interface tunnel 1 (IP address of GigabitEthernet 2/0).
[DeviceA-Tunnel1] source 2002::11:1
# Configure a destination address for the interface tunnel 1 (IP address of GigabitEthernet 2/1 of Device
B).
[DeviceA-Tunnel1] destination 2002::22:1