H3C Technologies H3C SecPath F1000-E - Manual (Page 179)

33
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 1 bytes/sec, 0 packets/sec
Last 300 seconds output: 1 bytes/sec, 0 packets/sec
167 packets input, 10688 bytes
0 input error
170 packets output, 10880 bytes
0 output error
# Ping the IPv4 address of the peer interface GigabitEthernet 1/0 from Device A.
[DeviceA] ping 30.1.3.1
PING 30.1.3.1: 56 data bytes, press CTRL_C to break
Reply from 30.1.3.1: bytes=56 Sequence=1 ttl=255 time=46 ms
Reply from 30.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 30.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 30.1.3.1: bytes=56 Sequence=4 ttl=255 time=15 ms
Reply from 30.1.3.1: bytes=56 Sequence=5 ttl=255 time=16 ms
--- 30.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 15/21/46 ms
Configuring an IPv6 over IPv6 Tunnel
Configuration Prerequisites
Configure IP addresses for interfaces (such as the VLAN interface, GigabitEthernet interface, and
loopback interface) on the device to ensure normal communication. One of the interfaces will be used as
the source interface of the tunnel.
Configuration Procedure
Follow these steps to configure an IPv6 over IPv6 tunnel:
To do… Use the command… Remarks
Enter system view system-view —
Enable IPv6 ipv6
Required
By default, the IPv6 packet forwarding
function is disabled.
Enter tunnel interface view Interface tunnel number —
Configure an
IPv6 address
for the tunnel Configure an
IPv6 global
unicast address ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
Required
Use one of the commands.