H3C Technologies H3C SecPath F1000-E - Manual (Page 175)

29
The Maximum Transmit Unit is 64000
Internet Address is 10.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source 3.1.1.1, destination 2.1.1.1
Tunnel protocol/transport IP/IP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
5 packets input, 320 bytes
0 input error
9 packets output, 576 bytes
0 output error
# Ping the IPv4 address of the peer interface GigabitEthernet 1/0 from Device A.
[DeviceA] ping 10.1.3.1
PING 10.1.3.1: 56 data bytes, press CTRL_C to break
Reply from 10.1.3.1: bytes=56 Sequence=1 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=4 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=5 ttl=255 time=15 ms
--- 10.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 15/15/16 ms
Configuring an IPv4 over IPv6 Tunnel
Configuration Prerequisites
Configure IP addresses for interfaces (such as the VLAN interface, GigabitEthernet interface, and
loopback interface) on the device to ensure normal communication. One of the interfaces will be used as
the source interface of the tunnel.
Configuration Procedure
Follow these steps to configure an IPv4 over IPv6 tunnel:
To do… Use the command… Remarks
Enter system view system-view —
Enable IPv6 ipv6
Required
By default, the IPv6 packet forwarding
function is disabled.
Enter tunnel interface view interface tunnel number —