H3C Technologies H3C SecPath F1000-E - Manual (Page 174)

28
[DeviceB-GigabitEthernet1/1] quit
# Configure an IPv4 address for GigabitEthernet 2/1 (the physical interface of the tunnel).
[DeviceB] interface GigabitEthernet 2/1
[DeviceB-GigabitEthernet2/1] ip address 3.1.1.1 255.255.255.0
[DeviceB-GigabitEthernet2/1] quit
# Create the interface tunnel 2.
[DeviceB] interface tunnel 2
# Configure an IPv4 address for the interface tunnel 2.
[DeviceB-Tunnel2] ip address 10.1.2.2 255.255.255.0
# Configure the tunnel encapsulation mode.
[DeviceB-Tunnel2] tunnel-protocol ipv4-ipv4
# Configure the source address for the interface tunnel 2 (IP address of GigabitEthernet 2/1).
[DeviceB-Tunnel2] source 3.1.1.1
# Configure a destination address for the interface tunnel 2 (IP address of GigabitEthernet 2/0 of Device
A).
[DeviceB-Tunnel2] destination 2.1.1.1
[DeviceB-Tunnel2] quit
# Configure a static route from Device B through the interface tunnel 2 to Group 1.
[DeviceB] ip route-static 10.1.1.0 255.255.255.0 tunnel 2
Configuration verification
After the above configuration, display the status of the tunnel interfaces on Device A and Device B,
respectively.
[DeviceA] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source 2.1.1.1, destination 3.1.1.1
Tunnel protocol/transport IP/IP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 2 bytes/sec, 0 packets/sec
4 packets input, 256 bytes
0 input error
12 packets output, 768 bytes
0 output error
[DeviceB] display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface