H3C Technologies H3C SecPath F5000-S Firewall - Manual (Page 31)

22
2. Connect one end of the AC power cord to the AC-input power receptacle on the firewall.
3. Pull the bail latch down to secure the plug to the power receptacle.
4. Connect the other end of the power cord to the AC power outlet.
Figure 19 Connecting the AC power cord
Connecting a DC power cord
1. Correctly orient the DC power cord plug with the power receptacle on the power module, and
insert the plug into the receptacle.
The receptacle is foolproof. If you cannot insert the plug into the receptacle, re-orient the plug
rather than use excessive force to push it in.
2. Fasten the captive screws on the power cord plug with a Phillips screwdriver to secure the power
cable.
3. Connect the other end of the power cord to the DC power source.