H3C Technologies H3C SecPath F5000-S Firewall - Manual (Page 37)

28
Figure 26 Setting terminal emulation in test Properties dialog box
Powering on the firewall
Checking before power-on
WARNING!
Locate the emergency power-off switch in the room before power-on so you can quickly shut power off
when an electrical accident occurs.
Before powering on the firewall, verify that:
• The power cord and grounding cable are properly connected.
• The input power voltage is as required.
• The console cable is properly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been correctly set.
• The interface card (if any) is correctly installed.
Powering on the firewall
1. Switch on the power source of the firewall.
2. Switch on the AC or DC power module.