Grass Valley Aurora Browse v.7.0 Installation User Manual

Page 159

Advertising
background image

April 6, 2010

Aurora Browse Installation and Configuration Guide

159

Restoring from the generic recovery disk image on E:

13. Depending on the partitions you are restoring, do one of the following:

• If you are restoring only the C: partition, select

No, I do not

and then click

Next

.

The “…ready to proceed…” page opens.

Skip ahead to step 20.

• If you are also restoring the D: partition, select

Yes, I want to restore another

partition or hard disk drive

and then click

Next

.

The Partition or Disk to Restore page opens. Continue with the next step in this
procedure.

14. Select

Data (D:)

and then click

Next

.

The Restored Partition Location page opens.

15. Select

Data (D:)

and then click

Next

.

The Restored Partition Type page opens.

16. Leave the selection at

Primary

and then click

Next

.

The Restored Partition Size page opens.

17. Leave settings at their defaults. The size reported in the upper pane is the size

detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click

Next

.

The Next Selection page opens.

18. Select

No, I do not

and then click

Next

.

The Restore Operation option page opens.

19. Do not make any selections. Click

Next

.

The “…ready to proceed…” page opens.

20. Verify that you are restoring the correct partition or partitions. Click

Proceed

.

The Operation Progress page opens and displays progress.

21. When a “The data was successfully restored” message appears, click

OK

.

22. Click

Operations | Exit

to exit the Acronis True Image program.

The MediaFrame server restarts automatically.

23. Remove any CD currently in the CD drive while the MediaFrame server is shutting

down.

24. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup

as follows:

a. Set the Regional and Language Options and click

Next

.

b. Fill in the Personalize Your Software information. (For example, set the Name

and Organization to

gv

.)

c. Enter in Windows Product Key and click

Next

.

The Product Key is on a sticker on the top of the machine near the front right
corner.

Advertising