Grass Valley NewsBrowse Desktop Browsing System Installation v.2.0 - Manual (Page 105)

25 May 2004 NewsBrowse Installation and Configuration Guide 105
Deploy remaining machines for full system
Deploy remaining machines for full system
For the basic configuration path, after you have worked through all the configuration
stages and verified functionality at each stage, you deploy your remaining
NewsBrowse machines.
Do the following tasks to deploy your remaining NewsBrowse machines, as
appropriate for the machines included in your particular NewsBrowse system. For
instructions, refer to the applicable configuration stages early in this chapter.
• Add backup Profiles. Refer to “Configure media server: Single-channel encoder”
on page 52 and “Configure Profile MDIs” on page 60 .
• Add backup VTRs. Refer to “Configure Ingest Control: Single-channel encoder”
on page 50 and “Configure media server: Single-channel encoder” on page 52 .
• Deploy remaining single-channel encoders. Refer to “Encoder stand-alone stage”
on page 49 and “Encoder + Server stage” on page 64 .
• Deploy remaining ISS. Refer to “Image Support Server (ISS) stand-alone stage” on
page 75 and “ISS + Server stage” on page 80 .
• Deploy remaining sequential encoders. Refer to “Sequential encoder stand-alone
stage” on page 84 and “Sequential encoder + Server stage” on page 89 .
Add live monitor encoders
If your system uses live monitor encoders, add them to the system as follows:
1. If you have not already done so, cable and configure for network access similar to
the NewsBrowse server.
2. Connect the audio/video feed for an ingest channel.
3. Add live monitor encoders on the Ingest Scheduler Live Feeds configuration page.
4. On each live monitor encoder, start Windows Media Encoder. There should be a
Windows Media Encoder shortcut on the Windows desktop.
B
a
si
c
A
d
va
nc
ed
D
o
no
t m
odi
fy http:// root_nb_svr:280 Ingest Scheduler Live Feeds
! Select the MDI (Transfer service) for the single-channel encoder (ingest
channel) for which the live monitor encoder provides a video stream.
! Machine name (from host file) of the live monitor encoder.
! Port 8080 required.
! Adds the live monitor encoder as a live feed.
Currently added live monitor encoders.
! Removes the selected live monitor encoder.
Start or restart the Thomson Ingest Scheduler service.