Grass Valley NewsBrowse Desktop Browsing System Installation v.2.0 - Manual (Page 55)

25 May 2004 NewsBrowse Installation and Configuration Guide 55
Checklist: Encoder stand-alone stage
• State: SUCCEEDED
8. In Event Viewer, verify informational messages regarding the creation of the
assets.
NOTE: You may get some error messages in Event Viewer as the encoder attempts
to communicate completion information to MDI services. These can be ignored if
you've not yet configured the MDIs as in
“Managed Device Interface (MDI) stage”
on page 56 .
9. In the Ingest Client application, click Get Assets . For both the high-res and the
low-res assets, look for the following report:
• COMPLETE_OK
10.On the Profile system, use Media Manager to verify that a clip with the correct
duration was created. Note the location of the clip, as it is used in configuration
stage tests later in this chapter.
11.On the NAS, use Windows Explorer to verify that the MPEG clip was created.
Open and play the clip. Validate video and audio.
Checklist: Encoder stand-alone stage
Use the following check list to verify that the basic configuration and testing of the
single-channel encoder is complete.
" Audio/Video/Timecode connected properly
" NetTime server running
" Profile(s) record hi-res
" Encoder writes to NAS
" MPEG playback with audio