Grass Valley NV9641A v.1.0 - Manual (Page 62)

52
Operation
Summary
When a source is preset, prior to a take, the level buttons show the preset source on the middle
line of text and the buttons turn yellow:
After a take, the level buttons show the new source on the top line of text and on the XY status
button:
The bottom line of text always shows the level mnemonic.
Level Mapping
If a level was level-mapped, the first line is reverse-field and the middle line shows the source
level for the mapping.
MD Devices
In multi-destination (MD) mode, a set of selection buttons presents a set of MD devices. To
perform an MD take, you assign sources to as many MD devices as you like and then press ‘Take’.
The multiple takes occur simultaneously. Call these “dest” buttons for the sake of simplicity.
In this example, sources CAM4 and CAM5 were preset to 2 destinations, MON1 and MON2,
respectively:
The top line of text shows the current source. The middle line of text shows the preset source.
The bottom line shows the destination.
After a take, the preset source becomes the current source. The buttons show the current source
on the top line:
If a breakaway occurred (in X-Y mode) for a particular destination, the MD destination button
shows the destination mnemonic in reverse-field.
XY-STAT XY-STAT
CAM3 CAM3
VTR2 VTR2
CAM3 CAM3
CAM4 CAM4
SD SD
CAM3 CAM3
CAM4 CAM4
AES 1 2 AES 1 2
–––––––– ––––––––
–––––––– ––––––––
AES 3 4 AES 3 4
CAM3 CAM3
CAM4 CAM4
CTRL CTRL
Source CAM4 preset prior to a take.
Current source shown on XY status button
and in the top row on the level buttons.
XY-STAT XY-STAT
CAM4 CAM4
VTR2 VTR2
CAM4 CAM4
SD
SD
CAM4 CAM4
AES 1 2
AES 1 2
–––––––– ––––––––
–––––––– ––––––––
AES 3 4 AES 3 4
CAM4 CAM4
CTRL
CTRL
Source CAM4 now current, as shown on the
XY status button and level buttons.
VTR1
AES 1 2 AES 1 2
AES 3 4 AES 3 4
This example is the button for virtual level AES 3/4.
Level AES 1/2 (from the source VTR1) has been mapped to
AES 3/4 at the destination device.
CAM6 CAM6
CAM4 CAM4
MON1 MON1
VTR1 VTR1
CAM5 CAM5
MON2 MON2
• • • • • •
CAM4 CAM4
MON1
MON1
CAM5 CAM5
MON2
MON2
• • • • • •
CAM1 CAM1
VTR3
The reverse field lets you know that this destination has a
breakaway take. The top line of text represents the source for
the breakaway on the primary level of the route.