0 setup – Magnum Energy ME-RC Remote User Manual

Page 31

Advertising
background image

©2013 Magnum Energy, Inc.

24

3.0 Setup

Recharge – This setting determines the DC voltage set-point

to which the batteries are allowed to fall—while the charger is in the

Silent charge cycle—before the charger restarts and recharges to

the Chg Volts setting. This setting should be at the lowest DC volts

level that you want the batteries to fall before starting a new charge.
Default: 12.0 VDC (12v), 24.0 VDC (24v), 48.0 VDC (48v)
Range: 12.0-16.0 VDC (12v), 24.0-32.0 VDC (24v), 48.0-64.0

VDC (48v)

* Hold

VDC – This setting holds the battery voltage at the Chg

Volts setting. This is for a system that requires a constant charge volt-

age to be present at all times (see Figure 3-11)

.

Figure 3-11, Hold VDC Charge Stages

Constant

Current

Constant Voltage

Voltage

Current

Max Amps

CV Charge

Volts

Hold VDC

TIME

CURRENT & VOLTAGE

◊ Battery Type (Custom) –

This selection allows you to individually

adjust the fl oat, absorb, and equalization charge voltage settings and to

set an equalization time for your batteries. The following Custom battery

settings display only if Custom has been selected from the 04 Battery

Type menu. Use these settings to determine the battery’s absorption,

fl oat, and equalization voltages, and the maximum amount of time spent

equalizing.

Absorb

Sets the level at which the charging voltage is held con-

stant during an Absorption cycle.

Default: 14.4V (12v), 28.8V (24v), 57.6V (48v)
Range: 12.0-16.0V (12v), 24.0-32.0V (24v), 48.0-64.0V (48v)

Float – Sets the level at which the charging voltage is held

constant

during a

Float cycle.

Default: 13.2V (12v), 26.4V (24v), 52.8V (48v)
Range: 12.0-16.0V (12v), 24.0-32.0V (24v), 48.0-64.0V (48v)

Equalize – Sets the level at which the charging voltage is held

constant during an Equalization cycle.
Note: Equalize volts cannot be set lower than the Absorb setting, or

more than 2 volts (12v systems), 4 volts (24v systems), or 8 volts

(48v systems) above the Absorb setting.
Default: 15.6V (12v), 31.2V (24v), 62.4V (48v)
Range: 12.0-16.0V (12v), 24.0-34.0V, 48.0-68.0V (48v)

Advertising