Enterasys Networks 6H2xx - Manual (Page 130)

General Configuration Screen
5-4 Module Configuration Menu Screens
5.2 GENERAL CONFIGURATION SCREEN
When to Use
To set the system date and time, IP address and subnet mask, the default gateway, the TFTP and
gateway IP address. This screen can also be used to clear the NVRAM, set the screen refresh time,
the screen lockout time, the IP fragmentation, the COM port configuration, and monitor the total
time (uptime) that the module has been running.
How to Access
Use the arrow keys to highlight the GENERAL CONFIGURATION menu item on the Module
Configuration Menu screen and press ENTER. The General Configuration screen,
Figure 5-2 ,
displays.
Screen Example
Figure 5-2 General Configuration Screen
352802_12
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Module Name: Module Date:
Module Time:
Screen Refresh Time:
Screen Lockout Time:
Com: [ENABLED] Application: [LM]
Clear NVRAM: [NO]
Module Uptime XX D XX H XX M
IP Fragmentation: [ENABLED]
Operational Mode: [802.1Q SWITCHING]
WebView: [ENABLED] Telnet: [ENABLED] Agg Mode: [SMARTTRUNKING]
Management Mode: [DISTRIBUTED]
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
sysName
RETURN SAVE
XX/XX/XXXX
14:23:00
30 sec.
15 min.
EXIT