Enterasys Networks 6H2xx - Manual (Page 410)

Example 6, Locking a MAC Address to a Port Using Classification Rules
13-38 VLAN Operation and Network Applications
3. Remove all ports from the Default VLAN Egress List as follows:
• The Default VLAN is selected from the Static VLAN Configuration screen to display the
Static VLAN Egress Configuration screen. The following is set using the Static VLAN
Egress Configuration screen:
SET ALL PORTS: NO
This configuration setting will cause the untagged frames sent to the Default VLAN from Ports
1 and 2 to be dropped because Ports 1 and 2 have been deleted from the Egress list of the Default
VLAN.
4. Create two source (src) MAC address classification rules and apply them to the Red VLAN
(VID 2), the following settings are entered using the VLAN Classification Configuration screen:
For the Red VLAN and Port 1:
• VID: 2
• Classification: src MAC Address
• Subclassification/MAC Address: 00.00.00.00.00.0A
• ADD the rule. It will display in the top half of the VLAN Classification Configuration screen.
5. Enter the following settings on the Protocol Port Configuration screen to assign two src MAC
address classification rules to Port 1 and add the classification to the Port VLAN List of Port 1:
• Port 1: YES to assign the classification rule to Port 1
• SET PORTS TO VLAN FORWARDING: YES to add the VLAN and classification rule to
the Port VLAN List of Port 1
For the Red VLAN and Port 2 set the following:
• VID: 2
• Classification: src MAC Address
• Subclassification/MAC Address: 00.00.00.00.00.0B
• ADD the rule. It will display in the top half of the VLAN Classification Configuration screen.
6. Enter the following settings on the Protocol Port Configuration screen to assign the new
classification rule to Port 2 and add the classification to the Port VLAN List of Port 2:
• Port 2: YES to assign the classification rule to Port 2
• SET PORTS TO VLAN FORWARDING: YES to add the VLAN and classification rule to
the Port VLAN List of Port 2.