Enterasys Networks 6H2xx - Manual (Page 136)

General Configuration Screen
5-10 Module Configuration Menu Screens
4. Use the arrow keys to highlight the SAVE command, then press ENTER. The warning screen
shown in Figure 5-4 displays.
Figure 5-4 Configuration Warning Screen, Subnet Mask
5. Use the arrow keys to highlight the YES command, then press ENTER. The changes are saved
and the module reboots.
5.2.3 Setting the Default Gateway
If the SNMP management station is on a different IP subnet than the module, a default gateway
must be specified. When an SNMP Trap is generated, the switch module sends out an ARP request
to the default gateway, which responds with its MAC address. The switch module then sends the
trap using the IP address from the Trap Table and the MAC address of the default gateway. To set
the default gateway, perform the following steps:
1. Use the arrow keys to highlight the Default Gateway field.
2. Enter the IP address of the default gateway using the DDN format.
For example: nnn.nnn.nnn.nnn
WARNING!
19601-84
YOU HAVE ELECTED TO SAVE ONE OR MORE CONFIGURATION
ITEMS THAT REQUIRE RESETTING THIS DEVICE.
ARE YOU SURE YOU WANT TO CONTINUE?
YES NO