Epson FX-980 - Manual (Page 23)

11 Getting to Know Your Printer
R4C3430
Rev. C
A5 size INTRO.FM
5/4/99 Pass 0
L Proof Sign-off:
E.Omori _______
<Kimura> _______
<Editor Name> _______
R If you use an extension cord with the printer, make sure the
total ampere rating of all devices plugged into the extension
cord does not exceed the cord’s ampere rating. Also, make
sure the total of all devices plugged into the wall outlet does
not exceed the wall outlet’s ampere rating.
R Unplug the printer before cleaning, and clean it with a damp
cloth only.
R Do not spill liquid on the printer.
R Except as specifically explained in this guide, do not attempt
to service the printer yourself.
R Unplug the printer and refer servicing to qualified
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered
the printer; if the printer has been dropped or the cabinet
damaged; or if the printer does not operate normally or
exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
R
Printer parts marked with this symbol may be hot.
Turn off the printer and let it cool for a few minutes
before you touch any printer part marked with this
symbol.
R If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and over-
current protection for this printer, the building installation
must be protected by a 16 Amp circuit breaker.
Note for German-speaking users:
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem 16
A-Überstromschalter abgesichert ist.
K