Epson FX-980 - Manual (Page 56)

2-10 Printing on Continuous Paper
R4C3430
Rev.C
A5 size CHAP2.FM
5/4/99 Pass 0
L Proof Sign-off:
E.Omori _______
<Kimura> _______
<Editor Name> _______
11. Turn on the printer. You may need to check and change the
printer driver settings as described in Chapter 4. When the
printer receives data, it automatically loads the paper and
starts printing. The printed pages are fed over the paper guide
toward the back of the printer.
12. After you finish printing, follow the steps in the next section
to tear off your printed document. If the first printed line on
your page appears too high or low, you can change its position
by using the micro adjust feature. See “Adjusting the Top-of-
Form Position” on page 2-38.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Removing a printed document from the rear push tractor
To remove the printed document, follow these steps:
1. Make sure the Tear Off/Bin lights are flashing. (This indicates
your paper is at the current tear-off position.) You may need
to press the
Tear Off/Bin button.
2-20a.eps
2-21.eps