Epson FX-980 - Manual (Page 86)

2-40 Printing on Continuous Paper
R4C3430
Rev.C
A5 size CHAP2.FM
5/4/99 Pass 0
L Proof Sign-off:
E.Omori _______
<Kimura> _______
<Editor Name> _______
To adjust the top-of-form position for continuous paper
loaded on the pull tractor, see the following example:
First mark a point 6.5 mm above the paper’s perforation; then
position the paper so that the mark is even with the top edge
of the plastic ribbon cover. This gives you an 8.5 mm margin
on the next page, meaning the printer starts printing 8.5 mm
below the perforation. If you mark a point 5.5 mm above the
perforation, you get a 9.5 mm margin on the next page.
6. After you set the top-of-form position, press the Pause button
to exit micro adjust mode.