4 installing cables - safety, 4 emc compliance statements, 1 en 55022/as/nzs 3548 – Ericsson Multi-Format Receiver RX1290 User Manual
Page 28: 2 fcc, 1 ac power supply, Installing cables - safety -6, Emc compliance statements -6, En 55022/as/nzs 3548 -6, Fcc -6, Ac power supply -6
Installing the Equipment
2.3.4
Installing Cables - Safety
Power supply cables should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them. Pay particular attention to cables at
plugs, convenience receptacles, and the point where they exit from the appliance.
Do not run AC power cables in the same duct as signal leads. Do not move or install
equipment whilst it is still attached to the mains supply. Ensure safety and ESD
precautions are observed whilst inter-connecting equipment.
2.4
EMC Compliance Statements
2.4.1
EN 55022/AS/NZS 3548
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
2.4.2
FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the Reference Guide, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to
correct the interference at his/her own expense.
2.5
AC Supply Operating Voltage and Fusing – Safety
Information
2.5.1
AC Power Supply
The equipment operates from an wide-ranging mains power supply (100-240 V AC
50/60 Hz nominal) and is designed for use in ambient air temperature in the range
0
°C to +50°C. There are no links etc. to be altered for operation from different
supply voltages. The full Technical Specification is given in Annex B, Technical
Specification.
1
The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical Earth attached.
EN/LZT 790 0003/2 R1A
2-6