Ericsson Multi-Format Receiver RX1290 - Manual (Page 47)

Operating the Equipment Locally
3.5 Setting Up Preset Services (Menu 1)
3.5.1 Using Preset Services
This group allows up to 40 Services to be stored as presets. Selecting a Service
from the preset list in Menu 1 automatically reconfigures the Multi-Format Receiver
to receive that Service with its associated parameters set as stored.
3.5.2 Setting Up a Preset Service
Follow the steps in Table 3.5 to store the current Service as a preset.
Table 3.5 Setting Up a Preset Service
Step Action Result
1 Use the menus to set-up the unit
so that the required Service is
current.
(Refer to Section 3.7, Service
Configuration (Menu 3)). This selects the Service and associated
parameters for the preset process.
2 Go to Menu 1 to view the Preset
menu.
This displays the menu which allows the
Current Service to be stored at a chosen
location (01 – 40). If there is no Current
Service, the menu display reads NO STORED
SERVICE.
3 Select a location to store the
preset. The Edit mode cannot
be entered unless a valid
Service being decoded. Use Edit and the arrow pushbuttons to step
through the stored items. This allows a specific
location to be chosen. Any vacant locations
are marked by NO STORED SERVICE.
4 Press Save. This stores the current Service and its
associated parameters as a preset in the
selected location. This adds the Service to the
list displayed on page 1.
EN/LZT 790 0003/2 R1A 3-9