Ericsson Multi-Format Receiver RX1290 - Manual (Page 56)

Operating the Equipment Locally
Step Action Result
3 Scroll to Menu 3.3.4 and edit the
Audio 1 digital output format
(AES3 or AC-3) and output
routing (STEREO, MIXED TO
BOTH, LEFT TO BOTH, or
RIGHT TO BOTH). Press Save. Edits the Audio 1 digital output format and
output routing.
Note that when the input signal is STEREO,
the Audio digital output format will always be
STEREO.
4 Scroll to Menu 3.3.5 and edit the
clipping value (12 – 24 dB).
Press Save. Edits the clipping value.
5 Scroll to Menu 3.3.6 and edit the
AC-3 down mix parameter
(SURROUND STEREO or
CONVENTIONAL STEREO)
Press Save. Edits the AC-3 down mix parameter.
6 Go to the Menu 3.4 for Audio 2,
Menu 3.5 for Audio 3, Menu 3.6
for Audio 4 and repeat steps 2
through 5. Selects the audio component.
3.7.9 Setting Up Asynchronous Data (RS-232)
These menu pages allow status monitoring and configuration of the low speed data.
Table 3.18 Setting Up Async Data
Step Action Result
1 Go to Menu 3.7 and press
Edit. Select the data stream
PID. Selects the data stream.
2 Scroll to Menu 3.7.1 and edit
the low speed data output
(ENABLED or DISABLED).
Press Save. The unit receives and displays the correct bit-
rate.
3.7.10 Setting Up High Speed Data Over Ethernet – RX1290/SWO/HSETHER
These menu pages allow status monitoring and configuration of the high speed data
over Ethernet software option.
Table 3.19 Setting Up High speed Data over Ethernet
Step Action Result
1 Go to Menu 3.8 and press
Edit. Select the data stream
PID. Selects the data user PID number.
EN/LZT 790 0003/2 R1A 3-18