Ericsson Multi-Format Receiver RX1290 - Manual (Page 33)

Installing the Equipment
2.7.2 ASI/HD-SDI/SD-SDI OUT
The unit has three ASI/SMPTE 292M video (HD-SDI)/656 video
(SD-SDI) outputs in the standard configuration.
The output standard must be selected from the user interface or
remote control interface.
The ASI/HD-SDI/SD-SDI output is coaxial via BNC connectors.
Video control is through the Video Menu (Menu 3.1).
Table 2.3 Digital Output Connector
ASI/HD-SDI/SD-SDI
OUT 1/2/3
Item Specification
Connector type BNC 75 Ω female socket
Connector designation ASI/HD-SDI/SD-SDI OUT 1
ASI/HD-SDI/SD-SDI OUT 2
ASI/HD-SDI/SD-SDI OUT 3
Pin-outs Centre
Shield Video output
Ground/Chassis
Note: These sockets are under the control of Menu 5.1
2.7.3 CVBS
A BNC socket is provided for composite video output which
supports NTSC(M) (with and without pedestal) and
PAL(B,D,H,I,M).
Table 2.4 Digital Output Connector
CVBS
AUDIO 1 / 2
5 1
6 9
Item Specification
Connector type BNC 75 Ω female socket
Connector designation ASI/HD-SDI/SD-SDI OUT 1
ASI/HD-SDI/SD-SDI OUT 2
ASI/HD-SDI/SD-SDI OUT 3
Pin-outs Centre
Shield Video output
Ground/Chassis
2.7.4 Audio Outputs
A pair of 9-way male D-type connectors provide two stereo
channels. Each connector carries a single channel of a stereo
pair in both analogue and balanced digital form.
Audio control is through the Service Menu (Menu 3).
EN/LZT 790 0003/2 R1A 2-11