Ericsson Multi-Format Receiver RX1290 - Manual (Page 52)

Operating the Equipment Locally
Step Action Result
12 Return to Input Menu 2, it
should display the current
status. If status is NOT
LOCKED, verify that the cable is
properly connected and that all
values have been entered
correctly.
3.7 Service Configuration (Menu 3)
3.7.1 Selecting and Setting Up a Service
Each Transport Stream may contain many Services. Menu 3 allows a Service to be
chosen as current and the profile of its components to be specified. This Service will
be used as the power up default Service until a new Service is selected.
Table 3.10 Selecting a Service
Step Action Result
1 Go to Menu 3 and select the
required Service.
The Edit mode cannot be
entered unless there are
available Services. This page shows the total number of Services
available in the incoming Transport Stream. Use
Edit and the arrow pushbuttons to select the
required Service.
2 Press Save. This stores the Service as the Current Service.
3.7.2 Selecting the Video Component
Table 3.11 Selecting the Video Component
Step Action Result
1 Go to Menu 3.1 and press
Edit. Select one of the video
streams or enter a video
stream PID. Selects the video component.
2 Scroll to Menu 3.1.6 and edit
the parameter for setting the
response to loss of video
(FREEZE FRAME, BLACK
FRAME, BLUE FRAME,
75% BARS AND RED, BLUE
PLUS TEXT, RED PLUS
TEXT). Press Save. Perform a
system restart (see Section
3.12 Restarting the Unit). Edits the parameter for setting the response to
loss of video.
EN/LZT 790 0003/2 R1A 3-14