Afinia H+1 3D Printer - Manual (Page 11)

4. Printer Installation
4.1 Install the Print Board
There are two print boards in the
H+1
package.
Perf Glass Board: The one with many small holes on one side of the board.
Flex Glass Board: The one with no holes.
1. Choose the desired type of print board for the print job.
2. Open the front door.
3. Slide the board onto the build platform and make sure to push the board all the
way to the back.
4. Close the front door.
Contact
Afinia 3D
: support@
afinia.com
10
Figure 4.1 Install Print Board