Afinia H+1 3D Printer - Manual (Page 8)

3. Unboxing
3.1 Unboxing the
H+1
1.
Cut open the tape on the top of the cardboard box, and open the box from the top.
2.
Take out the two boards on the top foam, and remove the top foam.
3.
Remove the plastic cover and the square shaped foam wrapping around the
machine.
4. With two people, l
ift the printer out of the cardboard box using two handles on both
sides of the printer, and place it on a flat surface.
5.
Open the Top Lid and remove all the
tie-downs from the gantry
and foams inside
the printer. There are six
tie-downs
in the machine.
6.
Open the Front Door, and take out the two foams and two extruders beneath the
build platform
, as shown in the
figures below:
7.
Take out the roll of filament, the accessory box and the power cord
located
at the
bottom of the cardboard box.
8.
Put all the foams back to the box, and keep the box for the future use.
Contact
Afinia 3D
: support@
afinia
.com 7
Figure 1.3
Turn the foam 90 degrees and then
take it out of the machine.
Figure 1.2 Take out the extruder.