Afinia H+1 3D Printer - Manual (Page 19)

Table 5.2 Material Icon Description
Name Icon Description
Withdraw
To take out the filament inserted in the extruder unit with
the preset temperature.
Click the Withdraw icon. The up arrow on the button will
start moving upwards, indicating the extruder is heating
up. The extruder will start pushing the filament out once
the temperature reaches the melting temperature with a
beep.
You now can remove the filament from the tip of the
extruder.
Extrude
To load the filament into the extruder unit with the preset
temperature.
Click the Extrude icon. The down arrow on the button
will start moving downwards, indicating the extruder is
heating up. Once the extruder temperature reaches the
filament’s melting point, the machine will give off a beep,
and you can push the filament into the extruder and the
extruder will heat up the filament, and extrude through
the nozzle.
If the machine works properly, you will find an evenly
extruded string of filament coming out of the nozzle,
without bubbles or tangling as the extrusion
proceeds.
Stop
To stop the printer in the middle of an extruding or
withdrawing process.
Click the STOP icon, the up/down arrow on the buttons
will stop moving. The printer should stop fully from
extruding or withdrawing the filament.
STOP
Contact
Afinia 3D
: support@
afinia.com
18