Kramer 4x4 Audio and Dante Mixer - Manual (Page 50)

Kramer Electronics Ltd.
FC-404NETxl – Protocol 3000 48
Function Description Syntax Parameters/Attributes Example
X-SIGNAL-
PIPE? Get a pipe configuration
for an output port. This
is when we want to
“tee” a signal to another
output.
Used essentially into
FC-404NETxl to output
audio signal to
HEADPHONES jack.
This is an Extended
Protocol 3000
command.
COMMAND
#X-SIGNAL-PIPE?  <direction_type> . <port_format> .
<port_index> . <signal_type> . <index> <CR>
FEEDBACK
~nn@X-SIGNAL-PIPE  <direction_type> . <port_format> .
<port_index> . <signal_type> . <index> , <direction_type> .
<port_format> . <port_index> . <signal_type> . <index> <CR><LF>
The following attributes comprise
the signal ID:
▪ <direction_type> –
o IN
o OUT
▪ <port_type> –
o ANALOG_AUDIO
o DANTE
o ANALOG_JACK
▪ < port_index> – The port
number as printed on the front
or rear panel: 1 to 4 for analog
audio, and 1 for Dante
▪ <signal_type> – Signal ID
attribute:
o AUDIO
<index> – Indicates a specific
channel number when there are
multiple channels of the same type:
1 to 4 for Dante, and 1 for Analog
audio
Get the input/output that is
routed to the headphones:
#X-SIGNAL-
PIPE?
 out . analog_jack
. 1 . audio . 1 <CR>