Kramer 4x4 Audio and Dante Mixer - Manual (Page 8)

Kramer Electronics Ltd.
FC-404NETxl – Connecting FC-404NETxl 6
Connecting FC-404NETxl
Always switch off the power to each device before connecting it to your FC-404NETxl . After
connecting your FC-404NETxl , connect its power and then switch on the power to each
device.
Figure 3: Connecting to the FC-404NETxl Rear Panel
To connect FC-404NETxl as illustrated in the example in Figure 3 :
1. Connect up to four balanced audio sources, (for example, 2 microphones and the audio
output signals of the Kramer VS-411XS and a laptop) to the AUDIO INPUT 3-pin
terminal block connectors (1 to 4).
To set to dynamic or condenser microphone, see Adjusting Analog Audio Input
Parameters on page 22 .
2. Connect the AUDIO OUTPUT 3-pin terminal blocks to up to four balanced audio
acceptors, (for example, Kramer PA-240NET power amplifier).
3. Connect the Dante RJ-45 port to up to 4 Tx and 4 Rx audio channels, accepting PoE
(if supported), via the network.
4. Connect a control system (for example, a laptop) to the ETH RJ-45 connector .
5. If powering via PoE is not available, connect the power adapter to the FC-404NETxl and
plug the power adapter into the mains power supply.
Connecting the Inputs
Each input channel has a 3-pin terminal block connector that can accept either a balanced or
an unbalanced connection; however, an unbalanced connection requires some modifications.
The next two sections explain how to connect the
FC-404NETxl to its input source.
11
13