Kramer 4x4 Audio and Dante Mixer - Manual (Page 6)

Kramer Electronics Ltd.
FC-404NETxl – Defining FC-404NETxl 4
Defining FC-404NETxl
This section defines FC-404NETxl .
Figure 1: FC-404NETxl 4x4 Audio and Dante Mixer Front Panel
# Feature Function
OUT LEDs (1 to 4)
Lights green when a signal is present, lights red when clipping is detected.
IN LEDs (1 to 4)
Lights green when a signal is present, lights red when clipping is detected.
Use the embedded web pages to select line level, mic level or 48V for each
input.
SYNC LED
Lights green when Dante network is available or red if an error occurred.
SYS LED
Lights green for digital audio normal operation.
Flashes green when this unit is the Master clock.
Lights red if an error has occurred.
Rx LED
Lights green when an RS-232 signal is received.
Tx LED
Lights green when an RS-232 signal is transmitted.
HEADPHONES
3.5mm Mini Jack Connect to a headphone set.
ON LED Lights green when the device is powered.
Figure 2: FC-404NETxl 4x4 Audio and Dante Mixer Front Panel
# Feature Function
AUDIO INPUTS 3-pin Terminal
block Connectors (1 to 4) Connect to analog balanced mono line/mic level (with selectable
48V) sources.
AUDIO OUTPUTS 3-pin
Terminal block Connectors
(1 to 4) Connect to analog balanced mono line level acceptors.
Dante RJ-45 Connector Connect to Dante audio via the network. Provides 4 Tx channels
and 4 Rx channels. By default, DHCP is enabled.
RS-232 3-pin Terminal Block
Connector
Connect to a PC/serial controller.
ETHERNET RJ-45 Connector Connect to a PC via a LAN.
RESET Recessed Button Reset/reboot the device: press and release the button.
Reset to factory default values: press and hold the button for 30
secs.
12V DC Power Connector 12V DC connector for powering the unit.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15