Exabyte MAGNUM 1X7 LTO - Manual (Page 108)

92
P RODUCT M ANUAL 1012581
C
HAPTER
7—M
AINTENANCE
P
REPARING FOR
R
EPLACEMENT
Note: If your autoloader is installed in a rack, it is not necessary to remove the
autoloader from the rack to replace the tape drive. It is also not necessary
to disconnect the SCSI cable, terminator, or Ethernet cable from the back
of the autoloader as long as they do not interfere with your access to the
tape drive.
To prepare for replacement:
1. 1. 1. 1. Obtain these tools: a #1 Phillips screwdriver, a #2 Phillips screwdriver, and
a small flat-blade screwdriver.
2. 2. 2. 2. Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD). If possible, use an antistatic mat and a
grounded static protection wristband during installation. If a mat and
wristband are not available, touch a known grounded surface, such as a
computer’s metal chassis.
3. 3. 3. 3. Power off the autoloader (press the 0 on the back of the autoloader) and
disconnect the power cord.
Warning
Before performing any installation or maintenance procedures, be sure that the
autoloader’s power switch is off and that the power cord is disconnected from the
autoloader and the outlet.
Warnung
Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu achten,
daß der Autoloader-Netzschalter auf “Aus” gestellt ist und daß das Anschlußkabel
vom Autoloader und der Steckdose entfernt ist.
Advertencia
Antes de realizar cualquier procedimiento de instalación o de mantenimiento,
comprobar que el interruptor de alimentación de la biblioteca está apagado y que
el cable de alimentación no está enchufado ni a la biblioteca ni a la toma de
corriente.