Exabyte MAGNUM 1X7 LTO - Manual (Page 51)

O CTOBER 2006 M AGNUM 1 X 7 LTO A UTOLOADER 35
S
ETTING
C
ONFIGURATION
O
PTIONS
9. 9. 9. 9. Press (as needed) to return to the Home screen.
S
ETTING
E
THERNET
C
ONFIGURATION
O
PTIONS
Table 3-5 Ethernet configuration options
Remote
Management
Utility
The Remote Management utility allows you to connect to the
autoloader’s Ethernet interface to remotely monitor operations,
upgrade firmware, and create diagnostic listings. See:
ƒ
Connecting the library to Ethernet— page 18
ƒ Using the Remote Management utility— Chapter 4
Ethernet Configuring the autoloader’s Ethernet interface typically
involves specifying the library’s IP address, subnet mask, and
gateway address.
ƒ
IP address—Used to route information from the autoloader to
the server. You can choose between dynamic
(server-assigned) or static (user-assigned) addressing for the IP
address.
ƒ Subnet Mask—Used to route information to designated
devices within the network.
ƒ Gateway address—Allows information to be routed outside
the subnet.
Network
Addresses
This allows you to select the method used to set the Internet
Protocol (IP) address for the library, as follows:
ƒ
Static—The library uses a fixed IP Address, which is assigned
in the IP Address option.
ƒ DHCP—The library uses an IP address assigned by the
network DHCP (Dynamic Host Configuration Protocol)
server.