Exabyte MAGNUM 1X7 LTO - Manual (Page 71)

O CTOBER 2006 M AGNUM 1 X 7 LTO A UTOLOADER 55
S
ETTING
C
ONFIGURATION
O
PTIONS
C
HANGE
L
IBRARY
C
ONFIGURATION
In the Change Library Configuration section, you can change the following
settings:
Field Description
Library SCSI ID
and Drive 1
SCSI ID
You can change the SCSI IDs for the autoloader or tape
drive if they conflict with other devices on the SCSI bus. See
page 29 for more information about SCSI IDs.
New Control
Mode
The default robot control mode for the autoloader is
Random. When operating in Random mode, the
autoloader processes cartridges according to commands
issued by an application. If you want the autoloader to
process cartridges sequentially, without instructions from an
application, you can set the control mode to Sequential. If
you select Sequential mode, set the Loop and Restart
options as desired. See page 38 for information about
Sequential mode and the Loop and Restart options.
New Front
Panel Access
Password,
Confirm New
Access
Password,
Current Access
Password
If desired, you can use the Remote Management utility to
change the password that protects access to the
autoloader’s menus from the front panel. (See page 40 for
more information about password protecting the front
panel menus.)
To set or change this password, enter a new password in the
New Front Panel Access Password field. The password can
be from 1 to 6 characters and can include spaces. The
password is not case-sensitive. Re-enter the new password
in the Confirm New Access Password field. If you are
changing an existing password, enter the current password
in the Current Access Password Field.
To cancel an existing password, enter the current password
in the Current Access Password Field and leave the New
Front Panel Access Password and Confirm New Access
Password fields blank.
Note: The front panel access password is separate from
the web access password that prevents using the
Remote Management utility to make changes to
the autoloader’s configuration (see page 58 ).
This password is separate from the web access
password that prevents using the Remote
Management utility to make changes to the
autoloader’s configuration (see page 58 ).