Exabyte MAGNUM 1X7 LTO - Manual (Page 130)

114
P RODUCT M ANUAL 1012581
C
HAPTER
9—S
HIPPING THE
A
UTOLOADER
R
EMOVING THE
A
UTOLOADER FROM THE
R
ACK
If the autoloader is installed in a rack, remove it as described below.
1. 1. 1. 1. From the back of the rack, use a #1 Phillips screwdriver to remove the two
screws that secure the autoloader to the rails (see Figure 9-1 ). Save the
screws.
2. 2. 2. 2. From the front of the rack, slide the autoloader forward and out of the rack
(see Figure 9-2 ).
! ! ! !
Important Do not ship the rack-mounting hardware if you are returning the
autoloader for service.
Figure 9-1 Removing the screws securing the autoloader to the rails
Figure 9-2 Removing the autoloader from the rack
Remove this screw
(one each side)