Exabyte MAGNUM 1X7 LTO - Manual (Page 111)

O CTOBER 2006 M AGNUM 1 X 7 LTO A UTOLOADER 95
R
EPLACING THE
T
APE
D
RIVE
 Full height tape drive: Note the orientation of the brackets, then using a
#1 Phillips screwdriver, remove the two screws from each of the
brackets attached to the tape drive (see Figure 7-5 ). Save the brackets and
screws to attach to the new tape drive.
I
NSTALLING THE
N
EW
T
APE
D
RIVE
To install the new tape drive:
1. 1. 1. 1. Remove the faceplate—Follow these steps to remove the faceplate.
a. a. a. a. Using a #2 phillips screwdriver, remove the three screws securing the
face plate to the tape drive chassis (see Figure 7-6 ).
Figure 7-5 Removing the brackets from the tape drive
Brackets
! ! ! !
Important The replacement tape drive must be preconfigured for use in the
autoloader. Purchase replacement tape drives from Exabyte or an
Exabyte-approved supplier.
Figure 7-6 LTO full height tape drive with faceplate
Faceplate
(must be removed)
Screw
Screw
(one on each side)