HP 3200m - Manual (Page 201)

EN Resolving control panel error messages
199
INVALID DATE An invalid date was entered, such as June
35. Reenter the date.
INVALID TIME An invalid time was entered, such as
25:99 PM. Reenter the time.
JOB SETTINGS
CLEARED The product has cleared job settings. Reenter any desired job settings.
MEMORY LOW.
ONLY 1
COPY. PRESS
[STOP] The product completed making one copy.
The remaining copies have been
canceled due to low product memory. Press E NTER /M ENU to clear the error.
Use the HP LaserJet Director to make
multiple copies of large documents, or
break the job into smaller jobs
containing fewer pages.
MEMORY LOW.
[STOP] TO
CANCEL. The product memory has been almost
completely filled. Allow the product to finish the job or
press
S TOP /C LEAR to cancel the job.
NO DIAL TONE. The product could not detect a dial tone. Unplug the telephone cord from both the
product and the wall, and replug the
cord.
Unplug the product telephone cord from
the wall, plug in a telephone, and try
making a call.
Plug the product phone cord into a jack
for another phone line.
See “Changing the detect dial tone
setting”.
See “Resolving fax problems” on
page 149.
NO DOCUMENT
SENT The fax forwarding setting is on, and the
product was unsuccessful in receiving a
fax because of low memory or some other
reason. The product deleted the
incomplete received data before
attempting to forward the deleted data. Print the faxes in memory and have the
sender resend the missing page(s) of
the document.
NO FAX
DETECTED The product answered the incoming call
but could not determine that the caller was
a fax machine. Ask the sender to try resending the fax.
Unplug the product telephone cord from
the wall, plug in a telephone, and try
making a call.
Plug the product phone cord into a jack
for another phone line.
See “Resolving fax problems”.
NO FAX PAGES
IN
MEMORY TO
REPRINT The product attempted to execute
“Reprint Last Fax” when nothing was in
memory. Receive a fax before attempting to use
this option.
NOT ENOUGH
MEMORY.
TRY AGAIN
LATER There is not enough memory to start a
new job. Wait until the current job is finished
before starting a new job.
Message Cause Solution