HP 3200m - Manual (Page 222)

220
Chapter 8 - Problem Solving and Product Maintenance EN
Using Memory (DIMMs)
The product has three slots for DIMMs (Dual in-line memory module).
You can find the DIMMs by opening the printer memory door located
on the back of the product. Two of the three slots are used but the
remaining third DIMM (closest to the printer memory door) can be
used for additional memory. You can purchase additional memory
from HP (see “Ordering parts” on page 257).
Use the two topics in this section to install or remove memory.
Adding memory
Adding memory (RAM only) to the product will enable you to print
more complex print jobs, store additional fonts, and store forms.
CAUTION
Static electricity can damage DIMMs. When handling DIMMs, either
wear a grounded anti-static wrist strap, or frequently touch the surface
of the DIMMs’ antistatic package and then touch bare metal on the
printer.
To install a DIMM, follow the instructions below:
1
Unplug the product.
2
Open the product memory door by gently pulling out and upward
on the bottom edge until the door supports itself.