HP 3200m - Manual (Page 203)

EN Resolving control panel error messages
201
RECEIVING FAX
BUSY
CANCELED FAX The fax line to which you were sending a
fax was busy. The product has cancelled
sending the fax. Call the recipient to ensure that fax
machine is on and ready.
Check that you are dialing the correct
fax number.
Check that the redial on busy option is
enabled.
Press and hold
S TOP /C LEAR for seven
seconds to check for a dial tone.
Unplug the product telephone cord from
the wall, plug in a telephone, and try
making a call.
Plug the product phone cord into a jack
for another phone line.
See “Resolving fax problems” on
page 149.
RECEIVING FAX
BUSY
REDIAL
PENDING The fax line to which you were sending a
fax was busy. The product automatically
redials the busy number. (See “Changing
how the product redials” on page 83.) Allow the product to retry sending the
fax.
Call the recipient to ensure that fax
machine is on and ready.
Check that you are dialing the correct
fax number.
Unplug the product telephone cord from
the wall, plug in a telephone, and try
making a call.
Plug the product phone cord into a jack
for another phone line.
See “Resolving fax problems” on
page 149.
SCANNER
RESERVED
FOR PC SCAN The product is being used to create a
scan by a PC. Wait until the PC scan has finished,
cancel the scan from the PC software,
or press
S TOP /C LEAR .
SCANNING
ERROR.
CANNOT
CONNTECT TO
PC The product cannot transmit scanned
information to a PC. Check the PC connection cable, and try
the scan again.
SPEED DIAL
(NUMBER) NOT
PROGRAM-MED The one-touch key or speed-dial code has
not been programmed, and therefore
cannot be added to a group. Choose a speed-dial code to which you
have already assigned a fax number. To
check which speed-dial codes have
been programmed, see “Printing a one-
touch, speed-dial, and group-dial report”
on page 47.
Message Cause Solution