Husky HME-423E - Manual (Page 11)

Hardware Installations
2-4
2-5 Installing Your Ethernet Direct Switch
Unpack the HME-421E/423E from the packing box. Please refer to Package Checklist section to see if any
item is missing or damaged. The installation steps include Mounting The Switch, Wiring The Power Inputs,
Wiring The Fault Alarm Contact
, and Cabling.
2-5.1 Mounting The Switch
The are two types of mounting options: DIN-Rail mounting, and wall mounting. Users can choose the most
suitable mounting installation for your own onsite applications.
2-5.1.1 DIN-Rail Mounting
The DIN-Rail mounting kit is attached to the back panel of HME-421E/423E by default. If not, or
users want to disassemble the DIN-Rail mounting kit from the HME-421E/423E, follow the steps
below.
To attach the DIN-Rail mounting kit:
1. Screw the DIN-Rail kit to the position shown in the figure below.
2. To detach DIN-Rail kit from the switch, reverse the step 1.
Follow the steps below for mount the switch onto the track.
1. Insert the top of DIN-Rail plate into the track.
2. Lightly push the DIN-Rail plate into the track.