Husky HME-423E - Manual (Page 42)

Configuration Using a Web Browser
4-26
Leave Group
A message sent by a host to the querier to indicate that the host has quit
to be a member of a specific multicast group.
This feature allows the administrator to enable IGMP protocol and IGMP Query function. The administrator
will see the IGMP snooping information in this section -- different multicast group VIDs and member ports,
and IP multicast addresses range from 224.0.0.0 through 239.255.255.255.
After finishing necessary configurations, click on Apply to save the settings.
4-6.14 SNMP Configuration
Simple Network Management Protocol (SNMP) is used to monitor exchange of information among devices in
a network system. HME-421E/423E supports SNMP v1/v2c/v3.
4-6.14.1 Community Strings
This function is to use community strings for authentication.
Strings This feature allows the administrator to enter a name for the string.
RO
RO means Read Only. This feature allows the requests accompanied by
this string to display MIB-object information.
RW
RW means Read & Write. This feature allows the requests accompanied
by this string to display MIB-object information and to set MIB object.
Agent Mode
This feature allows the administrator to select the SNMP version for
necessary configuration. Click on the version option required, and then
click on Change to validate the settings.
After finishing necessary configurations, click on Apply to save the settings.