Husky HME-423E - Manual (Page 72)

Command Set Lists
C-10
View Name] [Notify View
Name]
no snmpv3 mibview view
[View Name]
type
[Excluded|Included]
sub-oid
[OID]
G
Remove specified
mibview table of SNMPV3
agent. switch(config)#no snmpv3 mibview
view V1 type Excluded sub-oid 1.3.6.1
C-11 Port Mirroring Commands Set
Commands Level Description Example
monitor
[RX|TX|Both]
I
Configure source port of
monitor function switch(config)#interface fastEthernet 2
switch(config-if)#monitor RX
monitor rx [Port ID]
G
Set RX destination port of
monitor function switch(config)#monitor rx 2
monitor tx [Port ID]
G
Set TX destination port of
monitor function switch(config)#monitor tx 3
show monitor
P
Show port monitor
information switch#show monitor
show monitor
I
Show port monitor
information switch(config)#interface fastEthernet 2
switch(config-if)#show monitor
no monitor
I
Disable source port of
monitor function switch(config)#interface fastEthernet 2
switch(config-if)#no monitor
C-12 802.1x Commands Set
Commands Level Description Example
8021x enable
G
Use the 802.1x global
configuration command to
enable 802.1x protocols. switch(config)# 8021x enable
8021x system radiusip
[IP address]
G
Use the 802.1x system
radius IP global
configuration command to
change the radius server
IP. switch(config)# 8021x system radiusip
192.168.1.1
8021x system serverport
[port ID]
G Use the 802.1x system
server port global
configuration command to
change the radius server
port. switch(config)# 8021x system
serverport 1812
8021x system accountport
[port ID]
G
Use the 802.1x system
account port global
configuration command to
change the accounting
port. switch(config)# 8021x system
accountport 1813
8021x system sharedkey
[ID]
G
Use the 802.1x system
share key global
configuration command to
change the shared key
value. switch(config)# 8021x system
sharedkey 123456
8021x system nasid
[words]
G
Use the 802.1x system
nasid global configuration switch(config)# 8021x system nasid
test1