Trunk commands set, Vlan commands set, C-4 trunk commands set – Husky HME-423E User Manual

Page 66: C-5 vlan commands set

Advertising
background image

Command Set Lists

C-4

show interface configuration

I

Show interface
configuration status

switch(config)#interface fastEthernet 2
switch(config-if)#show interface
configuration

show interface status

I

Show interface actual
status

switch(config)#interface fastEthernet 2
switch(config-if)#show interface status

show interface accounting

I

Show interface statistic
counter

switch(config)#interface fastEthernet 2
switch(config-if)#show interface
accounting

no accounting

I

Clear interface
accounting information

switch(config)#interface fastEthernet 2
switch(config-if)#no accounting

C-4 Trunk Commands Set

Commands

Level Description

Example

aggregator priority

[1~65535]

G

Set port group system
priority

switch(config)#aggregator priority 22

aggregator activityport

[Group ID]
[Port Numbers]

G

Set activity port

switch(config)#aggregator activityport
2

aggregator group

[GroupID] [Port-list]

lacp
workp

[Workport]

G

Assign a trunk group with
LACP active.
[GroupID]: 1~3
[Port-list]: Member port
list. This parameter could
be a port range (ex.1-4) or
a port list separate by a
comma (ex.2, 3, 6)
[Workport]: The amount of
work ports. This value
could not be less than
zero or be large than the
amount of member ports.

switch(config)#aggregator group 1 1-4
lacp workp 2

or

switch(config)#aggregator group 2
1,4,3 lacp workp 3

aggregator group

[GroupID] [Port-list]

nolacp

G

Assign a static trunk
group.
[GroupID]:1~3
[Port-list]: Member port
list. This parameter could
be a port range (ex.1-4) or
a port list separate by a
comma ex.2, 3, 6)

switch(config)#aggregator group 1 2-4
nolacp

or

switch(config)#aggregator group 1
3,1,2 nolacp

show aggregator

P

Show the information of
trunk group

switch#show aggregator 1 or
switch#show aggregator 2 or
switch#show aggregator 3

no aggregator lacp

[GroupID]

G

Disable the LACP
function of trunk group

switch(config)#no aggreator lacp 1

no aggregator group

[GroupID]

G

Remove a trunk group

switch(config)#no aggreator group 2

C-5 VLAN Commands Set

Commands

Level Description

Example

Advertising