Husky HME-423E - Manual (Page 65)

Command Set Lists
C-3
duplex
[full | half]
I
Use the duplex
configuration command to
specify the duplex mode
of operation for Fast
Ethernet. switch(config)#interface fastEthernet 2
switch(config-if)#duplex full
speed
[10|100|1000|auto]
I
Use the speed
configuration command to
specify the speed mode
of operation for Fast
Ethernet. The speed can’t
be set to 1000Mbps if the
port isn’t a giga port. switch(config)#interface fastEthernet 2
switch(config-if)#speed 100
no flowcontrol I
Disable flow control of
interface switch(config-if)#no flowcontrol
security enable
I
Enable security of
interface switch(config)#interface fastEthernet 2
switch(config-if)#security enable
no security I
Disable security of
interface switch(config)#interface fastEthernet 2
switch(config-if)#no security
bandwidth type all I
Set interface ingress limit
frame type to “accept all
frame” switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all
bandwidth type
broadcast-multicast-flooded-
unicast
I
Set interface ingress limit
frame type to “accept
broadcast, multicast, and
flooded unicast frame” switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast-flooded-unicast
bandwidth type
broadcast-multicast I
Set interface ingress limit
frame type to “accept
broadcast and multicast
frame” switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast
bandwidth type
broadcast-only I
Set interface ingress limit
frame type to “only accept
broadcast frame” switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-only
bandwidth in
[Value]
I
Set interface input
bandwidth. Rate Range is
from 100 kbps to 102400
kbps or to 256000 kbps
for giga ports, and zero
means no limit. switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100
bandwidth out
[Value]
Set interface output
bandwidth. Rate Range is
from 100 kbps to 102400
kbps or to 256000 kbps
for giga ports, and zero
means no limit. switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
show bandwidth
I
Show interfaces
bandwidth control switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth
state
[Enable | Disable]
I
Use the state interface
configuration command to
specify the state mode of
operation for Ethernet
ports. Use the disable
form of this command to
disable the port. switch(config)#interface fastEthernet 2
switch(config-if)#state Disable